The Laversab 6300-W (6300W) RVSM is an aircraft pitot static tester that is designed to connect directly to an aircraft’s pitot-static system. This unit is the new generation model with built-in WIFI. Using the small and light-weight remote unit, a user can operate the tester from the cockpit and use it to test the entire pitot and static system of the aircraft, including altimeters, climb indicators, airspeed / Mach indicators, air data computers, and auto-pilots. The tester includes built-in vacuum and pressure pumps and emergency manual bleed-down valves.
Great for Testing:
Airspeed / Mach indicators
Air data computers
RVSM Compliant - The high accuracy of the tester and NIST-traceable calibration make the tester fully RVSM-compliant and suitable for use on all RVSM-compliant aircraft.
Automated Operation - Simply enter the target set-points for altitude and airspeed and the unit automatically achieves the targets, ramping at the programmed rates. Control at the set-point is stable within +/- 1 foot and +/- 0.1 knot.
Programmable Limits - User-programmable limits for altitude, airspeed, Mach, and VSI provide protection to the aircraft.
Jog and Hold Features - Set-points can be “jogged” up or down in small increments. Ramping to a set-point can be put on “hold” and controlled at the current measured value.
Ground Feature - Brings Pitot and Static outputs to ambient “ground” pressure after completing a test.
Profiles Feature - A profile of set-points can be downloaded from a PC, allowing the user to step through the set-points using a single key. Each profile can have up to 50 set-points and 20 profiles can be stored in the unit.
Leak Checks - Pitot and Static leak-checks can be performed either independently or simultaneously. Three leak-timers can be programmed to perform timed leaks between 1 to 20 minutes. The display of “instant” leak rates provides immediate feedback to the user.
Pressure & Vacuum Source - Built-in high-capacity dual vacuum pumps and pressure pumps provide the pressure and vacuum source for the unit. The pressure system includes a filter and membrane dryer to provide clean dry air for the entire system.
Remote Unit - The Remote unit is the operator interface for the tester. It is small and light enough to be used in the cockpit. The tester can be turned On and Off from the Remote. All valid parameters, including altitude, climb, and airspeed, are clearly displayed simultaneously on a single screen on the remote.
Manual Vent - The tester includes precision metering valves to enable manual venting of the aircraft’s pitot-static system, in the event of power-loss.
When is this unit used?
Leak-checks and Air-data-system accuracy-checks on all fixed-wing aircraft, helicopters and UAV's
Leak-checks and Air-data-system accuracy-checks on all RVSM aircraft.
Ideal for “C”-checks performed by commercial airlines.
Air Data Accessories Kits or Pitot/Static Adapters
View our full line of air data accessories kits or pitot/static adapters by Nav-Aids. Bundle with your new aircraft air-data pitot static tester.
Static Output - Pressure Function
Range: 0.1 to 42 inHg
Resolution: 0.001 inHg
Accuracy: +/- 0.002 inHg
Units: inHg, mbar
Static Output - Altitude Function
Range: -4000 ft. to 60,000 ft.
Resolution: 1 foot
Accuracy: +/- 2 ft. @ 0 ft., +/- 6 ft. @ 35,000 ft., +/- 12 ft. @ 50,000 ft.