4930015219777 - Tronair 06-5022-6600 – 2-Gallon Hydraulic Reservoir Service Unit – Skydrol/PE, Type IV Fluids

Using the wrong fluid can result in seal deterioration, internal corrosion, and contamination of the aircraft hydraulic system. The Tronair 06-5022-6600 hydraulic reservoir service unit is built specifically for phosphate ester fluids such as Skydrol, and substituting incompatible fluids may cause costly damage. Always refer to the fluid compatibility listed in the unit's specifications to ensure safe operation.

For best results, operators should pump the handle at a slow to moderate pace using steady pressure. Fast or erratic pumping is unnecessary and may create turbulent flow, which can lead to poor fluid transfer or system air entrapment. The system’s design optimizes efficiency with smooth, controlled operation.

The inline filter uses a non-bypass design, meaning no fluid will flow to the aircraft if the filter is clogged. This prevents contaminated fluid from reaching sensitive aircraft systems. If resistance is felt during pumping, discontinue use and clean or replace the filter before continuing service.

The inline filter can be removed and cleaned using clean hydraulic fluid or a neutral solution. Do not use chlorinated solvents for cleaning, as these can degrade materials. If the filter becomes permanently obstructed or damaged, it should be replaced to maintain optimal performance.

Yes! The Tronair 06-5022-6600 is shipped ready to use. The only required steps are to fill the reservoir with the appropriate fluid and purge the air from the system by operating the hand pump. This simplicity minimizes setup time and allows immediate deployment in the field or hangar.