Tronair 14-6885-6000 – Low-Pressure Regulator & Aircraft Tire Service Gauge

The Tronair 14-6885-6000 includes both a low-pressure regulator and an aircraft tire service gauge.

Low-Pressure Regulator

Features

• Outlet shutoff valve for controlled delivery
• Instrument is not affected by moisture, condensation, or other corrosive environmental conditions
• Unit is NOT Skydrol-resistant

Specifications

• Type: Two-stage
• Gas: Inert only – NO OXYGEN
• Delivery Range: 0 to 500 psig
• Gauge Accuracy: ASME Grade B 3-2-3
• Maximum Inlet Pressure: 4,000 psig
• Inlet Connection: CGA-580
• Hose Length: 15 ft. (4.6 m)
• Outlet Connection: High-pressure standard strut valve (.305-32" thread size) without valve core depressor

Aircraft Tire Service Gauge

Features

• Sealed and filled case with rubber case protector for shock absorption
• Liquid case offers increased reliability and extended calibration life
• Certification documents are provided at the time of shipping
• Unit is designed for low-pressure applications
• Instrument is not affected by moisture, condensation, or other corrosive environmental conditions
• Unit is NOT Skydrol-resistant
• All gauges require annual calibration
• Storage container for both tools is included

Specifications

• Maximum Operating Range: 100 psi (6.9 bar)
• Pressure Gauge Range: 0 to 100 psi (0 to 6.9 bar)
• Gauge Dial Graduations: 1 psi increments
• Accuracy: ±1.5% full-scale
• Dial Size: 2.5" (? cm)
• Temperature Range: -40°F to 150°F (-40°C to 65.6°C)
• Fill Fluid: Glycerin
• Lens Material: Plexiglas
• Hose Length: 16" (40.6 cm)
• Inlet Connection: Standard air valve (.305-32" thread size) without valve core
• Outlet Connection: Dual foot tire valve (.305-32" thread size) without valve core depressor

Calibration Information

The Certificates of Calibration supplied for the gauge(s) on this unit contain the calibration data for the actual instrument calibrated, along with the calibration date of the standard used to perform the calibration check.

The due date for instrument recalibration should be based on the date the instrument was placed in service in your facility. Recalibration should be done on a periodic basis as dictated by the end user's quality system or other overriding requirements.